hello when using large screen dimensions than 1633*768
some programs shows their interface in very small fonts and some of them would show that at the inner of the program after installed and usage which causes not to be able to use it normally.
sorry for my bad english 
Am I supposed to buy a screen gaurd for my laptop touch screen?
Hi guys,
So basically I started fresh installation on windows 10, and when I tried to pull out the tablet because this is a detachable ultrabook the tablet mode didnt went ON so here's what I already tried:
It just continues not to work, so I thought that the intel integrated sensor solution driver would work, but it happens I don't find the one for this specific model which by the way is from Portugal,
Cheers,
Alexandre Santos
Windows 10 Insider / Android Rom Tester
Hi,
Since I connected my EliteDisplay S140u with my computer a message is displayed "Addon_OSD.exe stop working "
This message is displayed when i start my computer...
Can anyone help me?
I have a hairline crack in the screen and would like to see if there is an HP repair center in Raleigh North carolina to replace it.
Also how much is the screen replacement for tis model?
HP spectre model N1R85UA#ABA
My panasonicTV screen is blank when PC is connected in HDMI but it all works ok on a differant TV
I have a Probook 6360b that does not display anything on the LCD. The LCD is lit, but there is no picture. There is a display when I connect the laptop to a monitor (VGA).
I have done the following to diagnose the issue:
-Tried a known working LCD from a "retired" 6360b - that didn't work in this computer
-updated the BIOS
- deleted the video driver, reinstalled, updated etc.
- did a hard reset of the system
-the hard drive works in another 6360b
-a known working hard drive from another 6360b does not display on the LCD either.
I can't get into the BIOS or diagnostic tests because by the time the laptop recognizes the external monitor, it is already on the log in screen.
I'm afraid it is the motherboard that is the issue. Any other suggestions are appreciated!
I have three external monitors I utilize in addition to the laptop screen. Currently I have one external monitor plugged into a VGA port and two external monitors with DVI cables run through seperate USB3.0 HDMI adqapters into a USB hub, then plugged into a USB port. Is there a better way to set this up as occasionally my monitors lock up and it won't play sound play on the computer. Please note The external monitors only have DVI and VGA ports on them. Also, I have a display port that is not currently being used.
Hello I'm looking at getting the OMEN 17-w202na laptop but it doesn't have a disk drive and I'm wondering if the Hp external dvd drive will work with this laptop
Howdy! I just purchased two HP 15-F222 laptops.
I followed all the instructions and connected to the Internet via my wireless connection.
However, I cannot figure out how to enter the @ symbol to provide my email for registration and other purposes. I've tried simply shift + 2 ... as well as all configurations of control keys + (or without +) the 2.
Either I get a quotation mark (") or nothing ... zilch ... just a blank screen.
Can someone please tell me how to insert the @ symbol using my new laptop's keyboard?
Thank you!
hi all i just formated my hardrive and installed windows 10, just upgraded some of my drivers but noticed my nvidia graphics card is only intel graphics 4600 , i need help getting back my nvidia as iv tried installing it and its not finding a compatable hardware pls what do i do, its not showing in device manager, iv downloaded most of them and its still not finding
I recently just got this brand new laptop for christmas, everything worked perfectly untill one day when an update occured the screen would seem like if a ghost were touching it , it will touch it self all over the place , its so annoying. i restored the computer and it worked a little while until it started happening again, i already tried the troubleshooting steps and none seem to work, I disabled the touchscreen driver- enabled it again, calibrated the screen, ran some tests and it just wont stop doing it, right now i have the driver disabled because it wont let me do anything without the screen touches , please help me.
can't access the camera; error code 0xA00F4244(0xC00D36D5). i checked the device manager and there were neither imaging devices nor camera driver. need hel
I just got my HP Probook 450 G3 a few days ago, and I have begun noticing a problem with my screen. Lines of black or white squares often show up when I open a new tab and go to a new page. Sometimes they stay for a while; other times they go away after some scrolling or movement of my cursor. What could be causing this, and is there a solution?
My roommate has the HP ENVY x360 (Model 15-u011dx) and I was thinking of buying it from him. I specifically want to use it for school. More specifically the One Note application where I can just upload lecture slides and draw on them. Pressure sensitivity is not that big of a deal for me, as long as I can write words and draw simple pictures with it. But to do that I would like a stylus for the touch screen. I've looked through several forums and they all say different things ranging from not working at all, to working perfectly fine with a Dell brand stylus (although I think I read somewhere that HP made an update that made this stylus obsolete I'm not sure). I'm just wondering if there really is a stylus out there can work for the make and model of this 2-in-1 laptop that can simply write words and basic pictures, but nothing too special like pressure sensitivity for intensive drawing or anything like that.
After updating from windows 8.1 to 10 my laptop started misbehaving, the laptop screen is behaving as if its disconnected and i can only use the extended/External screen trough the VGA port to operate the laptop.
how can i get this solved?
Does anyone know if there is a pen that works on a Pavillion x360?
I have the ENVY 17-J184na which has an Nvidia GEForce 840M video card.
When I had Windows 8 installed video editors used the Cuda features of the card.
Now I have Windows 10 I notice that edited videos render more slowly and even though I have the 840 set as the default in the Nvidia control panel, editing programmes report that the card being used is not Cuda capable.
I have tried uninstalling the latest Nvidia drivers installed by Win 10 updates and reverted to the older drivers off the HP site for my laptop model - but still no success.
Anyone experiencing this problem - or have any suggestions to remedy it.
Thanks
Hi
I'M Looking for an LCD cable with a webcam connection
I can not find the hp part number on the internet or cable itself.
I can only find this number: 350404E00-GG2-G
Can i order this cable from HP?
I come from the Netherlands no one store has this cable can anyone help me?
I dont want to buy from ebay
Thanks
hello sir,
i have hp pavilion dv6 6116tx.it include intel hd 3000 series graphic card 1gb radeon . plz help can i upgrade this graphic card to higher card.
